 |
 |
 |
|
AEM Water + Methanol Injection Kit:
AEM Water/Meth Injection Kit For use with gas engines with Forced Induction The Water/Meth Injection Kit is a safe and economical way to reduce air inlet temperatures to increase boost pressure for more power. Lower air inlet temperatures allow users to advance timing without having to run higher-octane fuel. This is the most complete kit available on the market straight out of the box- no additional parts required.
Once installed, the Water/Alcohol Injection kit uses a boost-dependent, variable-flow progressive controller to determine the amount of water/alcohol mixture (up to 50%) to feed into the inlet stream from the included one-gallon reservoir. The controller commands a progressive 150-psi pump that delivers the mixture, and flow adjustments at the inlet are made via three included jets designed to match most engine power requirements. The result is significant horsepower gains using pump gas-at about half the cost of racing fuel. |
|
|
|
|
|
 |
|
 |
|
Features
- Universal kit includes everything you need for installation
- Progressive, controller-driven 150 PSI pump
- One-gallon tank with integral fluid level sensor
- Dash light for system status and low fluid warning
- Alcohol Compatible (up to 50% in solution with water)
- Progressive controller, provides boost-dependent variable flow
- Output provided to either decrease timing or boost if the system runs out of fluid or detects an error
- Includes three jets to match your power requirement
|
|
|
 |
|
 |
|
